In 1928, the Bell system renamed the TU into the decibel, being one tenth of a newly defined unit for the base-10 logarithm of the power ratio. The definition was conveniently chosen such that 1 TU approximated 1 MSC specifically, 1 MSC was 1.056 TU. 1 TU was defined such that the number of TUs was ten times the base-10 logarithm of the ratio of measured power to a reference power. In 1924, Bell Telephone Laboratories received a favorable response to a new unit definition among members of the International Advisory Committee on Long Distance Telephony in Europe and replaced the MSC with the Transmission Unit (TU). A standard telephone cable was "a cable having uniformly distributed resistance of 88 ohms per loop-mile and uniformly distributed shunt capacitance of 0.054 microfarads per mile" (approximately corresponding to 19 gauge wire). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a listener. Until the mid-1920s, the unit for loss was Miles of Standard Cable (MSC). The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. In electronics, the gains of amplifiers, attenuation of signals, and signal-to-noise ratios are often expressed in decibels. Instead, the decibel is used for a wide variety of measurements in science and engineering, most prominently for sound power in acoustics, in electronics and control theory. The bel was named in honor of Alexander Graham Bell, but the bel is seldom used. The definition of the decibel originated in the measurement of transmission loss and power in telephony of the early 20th century in the Bell System in the United States. The decibel scales differ by a factor of two, so that the related power and root-power levels change by the same value in linear systems, where power is proportional to the square of amplitude. When expressing root-power quantities, a change in amplitude by a factor of 10 corresponds to a 20 dB change in level. That is, a change in power by a factor of 10 corresponds to a 10 dB change in level. When expressing a power ratio, it is defined as ten times the logarithm in base 10. Two principal types of scaling of the decibel are in common use. For example, for the reference value of 1 volt, a common suffix is " V" (e.g., "20 dBV"). In the latter case, the numeric value expresses the ratio of a value to a fixed reference value when used in this way, the unit symbol is often suffixed with letter codes that indicate the reference value. The unit expresses a relative change or an absolute value. Two signals whose levels differ by one decibel have a power ratio of 10 1/10 (approximately 1.26) or root-power ratio of 10 1⁄ 20 (approximately 1.12). It expresses the ratio of two values of a power or root-power quantity on a logarithmic scale. The decibel (symbol: dB) is a relative unit of measurement equal to one tenth of a bel ( B). For other uses, see Decibel (disambiguation). For use of this unit in sound measurements, see Sound pressure level. So, what's the quietest sound in the world? - Scientists at Orfield Labs, Minneapolis have found that by studying how subjects react in their anechoic chamber (also known as the world's quietest room) that the sound level in the room, which actually has the Guinness World Record, is -9 decibels, compared to the average "quiet" room's 30.This article is about the logarithmic unit. Their loudness ranges roughly from 240 dB to over 280 dB - only big volcanic eruptions are louder! Nuclear explosions are amongst the loudest phenomena on Earth. It was so loud that it ruptured eardrums of people 40 miles away, travelled around the world four times and was clearly heard 3,000 miles awayĪnd. The decibel scale is a bit strange because of the sensitivity of the human ear which can pick up everything from the sound of a fingertip brushing lightly over the skin to the sound of a loud jet engine - quite a difference! DBĭid you know - The world's loudest sound was the sound made by Krakatoa when it erupted in 1883. The decibel (dB) is used to measure sound level.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |